How to Remove Glued Down Wooden Flooring

Do you want to change the wooden flooring of your home and upgrade to something more beautiful, modern, and extravagant? In that case, the first thing you need to do is remove the current flooring, right?

Gluing down wooden floors is a very tedious, difficult, and labor-intensive task. However, with a little bit of guidance and effort, you can conveniently perform the task on your own. We are not discouraging the use of professional help, but what’s wrong with thinking to save some cash?

In this short guide, we are sharing a super easy method to remove glued down wooden flooring conveniently, all by you! But before that, let us take a look at some important factors you need to consider to understand the complexity of the task. Keep Reading, it will be helpful!


Factor to Consider Before Gluing Down the Wooden Floor:

As we have briefly mentioned above, there are a few factors you need to think about before kickstarting the process. Trust me; these factors will let you know how difficult and easy the task is going to be. Here are those factors:

Is the Current Installation Good?

The installation process of the current floor is the most important factor to consider. If you installed it yourself, then gluing down would be relatively easy; there would be no harsh use of adhesives. However, if the current flooring is installed by professionals, gluing down would be a little hard.

What Type of Flooring Is Installed?

The next important factor to consider is what type of flooring is originally installed? Some are easy to rip out, while some become extremely hard. So, it would be best if you identify the type first to be prepared for the complexity level.


The Tools You Will Need to Remove Glued Down Wooden Flooring:

  • 1 circular saw.
  • 1 pry bar.
  • 1 hammer

DIY Steps to Remove Glued Down Wooden Flooring

Here is an easy peasy method to remove your glued-down wooden flooring. You will need some basic tools for this process. Still, if you won’t have them, you can contact a local tool rental company or hardware store for hourly rates.

Step 1 – Find Your Starting Point

First of all, you need to identify where you want to start from. Just pick any one starting point; near the carpet, near the wall, etc. Once you are done deciding, take a circular saw and start cutting 1” x 1” inches wide floor squares.

After cutting the squares, take a pry bar or hammer and start removing that section from the flooring. Then, repeat this process for all the squares.

Step 2 – Remove the Boards

After removing the actual flooring, you will have access to the boards. Now, pick up the hammer and pry bar again. Start hammering the pry bar until it reaches under the end of the board. By doing this slowly, you will be able to take the whole board out.

At this point, you will feel the glue coming out from the floor. However, keep in mind to take the board out in one piece instead of cracking it; that will be easier to clean!

Step 3 – Remove the Planks

After you are done with both the wood and boards, the only thing left will be the wooden planks. Also, wooden planks will be the easiest parts to work with. In fact, only using a pry bar would be more than enough.

Step 4 – Clean!

After you are done with the whole floor, it is time for you to clean the mess. You can either dispose of the hardwood floor or contact any trash removal company to take that away!


Wrapping Up

Feeling inspired after this guide, right? What are you waiting for then? Pick up your tools and turn your DIY mode on. Just follow all the above-mentioned steps and give your house and floors a whole new look, yourself!

Moreover, don’t forget to give us your feedback in the comments below. You know we love to hear about thoughts, right? Also, if you still have any doubts and questions, feel free to ask!

Leave a Comment

Creative Commons License
Woodsybond.com by https://www.woodsybond.com is licensed under a Creative Commons Attribution-NoDerivatives 4.0 International License.
Share via
Copy link
Powered by Social Snap